Raisecom
ISCOM6820-GP (A) Installation Guide
8 Installation reference
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
40
Figure 8-4
Tail fiber binding tape
Step 5
The finished effect is shown in Figure 8-5.
Figure 8-5
Finished effect
8.1.4 Precautions
Comply with the following requirements when binding tail fibers.
The contact surface of the binding tape and tail fiber is the rough surface and the hook
surface of the binding tape does not contact with tail fiber.
Straighten out the tail fibers before binding them.
Tight the binding tape appropriately. Do not over tight it.
Under normal circumstances, the interval between the tail fiber binding locations is not
more than 40cm.
The number of tail fibers should not be appropriate; the number of 2mm tail fibers
should be controlled within 100; the number of 3mm tail fibers should be controlled
within 60; if there are too many tail fibers, bind them separately.
