Raise3D N2, Руководство по установке, Страница: 3 / 8

WWW.RAISE3D.COM
AMERICA · ASIA · EUROPE
Filament Run-out Sensor Installation Guide
Set the panel and screws aside.
STEP 3: Replace the Bowden Tube
1) If the original Bowden Tubes on your printer are with 4mm-OD :

Remove the original Bowden tubes completely and replace them with the included Bowden tubes
from the Run-Out Kit (D). To release the tubes, press and hold the blue ring on the coupling.
2) If the original Bowden Tubes on your printer are with 6mm-OD :

Keep the origin tubes and directly insert the new 4mm
–OD tubes to pass through.
N2: 10 screws
N2 Plus: 11 screws