RAIS Viva 100 L Classic Gas, Руководство по установке и эксплуатации

Страница: 13 / 72

13
English RAIS - User manual for VIVA L Gas
INSTALLATION
Several issues must be addressed when selecting a suitable location for your VIVA L.
The minimum clear- ances to combustible construction are listed below. In addition, ac-
cess to the gas supply must be considered. The location of the stove will also affect the
venting requirements and you must be certain the location will allow c ompliance with
the venting requirements. You must also insure that your installation provides adequate
accessibility clearance for servicing an d proper operation.
When the appliance is installed directly on carpeting or non-ceramic tile or other com-
bustible material other than wood flooring, the appliance shall be installed on a metal
or wood panel extending the full width and depth of the appliance. A commercially
available hearth pad meets this requirement.
Installation and repair should be done by a qualified service person. The appliance
should be inspected before use and at least annually by a professional service person.
More frequent cleaning may be required due to excessive lint from carpeting, bedding
material, etc. It is imperative that the control compartment, burners and circulating air
passageways of the appliance be kept clean.
Gas installation
Once it has been decided where the stove will be positioned, a gas installation should
be established in the vicinity of the stove so that the gas supply and stove can be con-
nected.
Ventilation
This stove has a sealed combustion chamber and is intended for a balanced draught.
There is therefore no need for an extra air supply.
It is recommended that sufficient fresh air is supplied to the room to maintain a com-
fortable environment.
This stove may be installed in a completely airtight building or a building with mechani-
cal ventilation.
UNPACKING AND PLACING THE VIVA L
By now, you will have removed the shipping carton from the base pallet. The VIVA L
is shipped in a specially designed shipping carton. Cut the strapping that secures the
stove to the pallet and remove the wooden cribbing from the top of the stove. Remove
the plastic bag that covers the stove. Remove the barrier (3711901) by unscrewing the
4 bolts holding the barrier, with the 3mm hex key fixed to the pallet and. Be careful not
to scratch the paint of the stove when removing the barrier. Open the door with the
10mm spanner fixed to the pa llet, by turning the two hooks holding the door. Remove
the package of logs and accessories that is packed inside the stove and set it aside. Lift
the stove up and off the pallet. Remove transit packing material. Remove any packing
material from inside the firebox.
The VIVA L
is equipped with leveling bolts to make it easier to install the stove on an
irregular surface. They can be adjusted later. Move the VIVA L to location where it will
be installed. Using as little adjustment as possible for each leveling bolt, adjust them as
needed to get the stove as level as possible both side to side and front to back.