RainWise PVmet 500 Series, Руководство пользователя

Страница: 9 / 29

- 9 -
the small N located on the ultrasonic anemometer. Both the screw for the topmast and the screw for the entire top unit must be
tightened to finalize the installation.
ELECTRICAL
Electrical connections should be verified before applying power to the unit to prevent the possibility of causing permanent
damage.
The PVmet-500is designed to be electrically robust if properly installed following the instructions in this manual. The enclosure has a
built-in latch on the right side of the unit. To open, push in on the latch and pull the cover open. This latch securely keeps the enclosure
closed, if additional security is needed there is an eye for a tag or padlock.
Cable quick entry/retention slots are located on the bottom side of the enclosure for easy installation of additional sensor cables as
shown in Figure 88.
Figure 8: Cable entry retaining slots
The rubber seals minimize dust and water intrusion. Care should be taken when placing new cables in the slots so that the cables do
not create large openings.