Mount the support tube as indicated; A tripod is
shown. You can also use U-bolts or a Mono Mount.
Insert the neck down end into the
MKIII
sensor as-
sembly until it bottoms with the retaining screw in
the slot. Tighten the screw.
1.
Rotate the assembly until the solar panel faces
TRUE SOUTH, TRUE NORTH if you are in the
southern hemisphere. Secure the support tube to
the assembly to prevent it from rotating.
2.
3.
This leaf wetness sensor is designed to be mounted on the
North side of the MK-III weather station. The bracket provided with the
sensor insures a solid and secure installation.
1. Loosen the two screws under the rain collec-
tor . Do not remove them completely.
2. Slide the sensor bracket into position between
the head of the screw and the large flat
washer.
3. Tighten the screws to secure both the leaf
wetness sensor and rain collector.
4. Plug the leaf wetness sensor connector into to
the MK-III.
5. Place the excess cable against the body of
the weather station as shown in the picture.
6.
Use the two cable ties supplied to secure the
cable to the rain collector support arms.
Installing the Leaf Wetness Sensor
This completes the MK-III installation!
Please refer to Computer Interface Instruction manual for details on how to
install and configure the receiving side of the weather station.
Adjust the solar panel angle for optimum performance. Use
the table below to determine your optimum angle.
Latitude
Panel Angle
(from vertical)
0° - 22.5°
60°
22.5° - 55°
30°
55° - 90°
15°
The top of the solar panel is hinged. Lift the bottom of the
solar panel up and insert the two support bars into the appro-
priate mounting holes in the solar panel.
4.
Turn the system on by pulling switch forward toward the front
of the unit. The switch will click into position. The system is
now transmitting.
5.
