Rainford RBH-4654 BF, Руководство пользователя

Страница: 16 / 72

16
GAS CONVERSION
Burners in your hob can be operated by different gases by installing injectors suited for
gases required to be fired. Contact with the authorized service for your gas type changes.
Injectors change should be carried out by the authorized service staff as follows;
 Remove fire bars and burners by lifting them upward.
 Remove injectors by turning counter-clockwise and reassemble new injectors
suited for gas types to be used.
(See Table 1)
 Tighten injectors properly.
IMPORTANT : Tightening the injector too much causes to become worn and
occur gas leakage, for this reason do not force too much when you make sure
of tightening the injector adequately.
 After installing the injectors, check the gas leakage by foam.
For this process, foam the bottom of injectors, push over the injector with your finger
so as to close the gas outlet and check whether bubbles occur in the connection point
of injector or not.
 In order to adjust injectors to minimum, turn the screw located on valve with a
screwdriver to minimum position.