7
Operating the Steamer
1. PLEASE READ THE SAFETY INSTRUCTIONS ON PAGE 2 OF
THIS MANUAL BEFORE OPERATING THE STEAMER
2. Do not leave the steamer unattended while waiting for steam
to generate.
3. To prevent children using the steamer you can lock the
Steam Release Button by pressing the Steam Lock Button.
4. Do not use the Rainbow Steamer on unsealed wood floors
or direct steam on any wood floor for extended time periods.
This may cause the wood grain to rise.
5. Steam Cleaning is not recommended for use on unsealed
wood surfaces, cold glass, or soft plastic surfaces.
6. Always check the manufacturer’s usage instructions
before using the Steamer on a surface.
7. Please note that the force and the heat of the steam from the
steamer may damage certain surfaces or textiles. Always
test on a small, concealed area of the surface or material
that you are steam cleaning.
1. Before using the Steamer attach the proper accessory for the type of surface to be
cleaned.
2. Plug the power cord into an electrical outlet. This will switch the power indicator lights on.
3. The green light indicates that the unit is plugged in.
4. The red light indicates that the unit is heating the water. When the red light goes off, the
unit is at full pressure and you are ready to begin cleaning.
5. Allow 3 - 5 minutes for the appliance to generate the steam.
6. Press the Steam Release Button to emit the steam and begin passing slowly over the
surface intended for cleaning.
7. For disinfecting areas, hold the steamer no more than one inch away from the surface
and pass over slowly until entire area is covered.
8. To deodorize and remove wrinkles, gently touch the fabric and pass the steamer in an up
and down motion over it. Wrinkles can be removed form either side depending on the
type of fabric.
9. Wax may be removed by the heat and steam action on wax-treated surfaces.
