4. Mechanical Installation
1.
The Filter unit ships without the piston installed
2.
Ensure that the o-ring is in place on the threads of the cylinder. Push the piston into the main body of filter. Ensure that the push to
connect fitting at the top of the piston lines up with the 1/4: black tubing.
3.
Push the 1/4" tubing into the push to connect fitting at the top of the Piston.
5. Electrical Installation
5.1 Battery
1.
Remove the top gray cover (push up the sides over the indent).
2.
Remove the black battery tray and install the 4x “D Cell” batteries as shown.
3.
The controller will come to life. It goes to sleep quickly, holding down any of the three lower buttons for a few seconds wakes it
back up.
4.
Press the far right (M) button on backwash controller to test that the installation has been succesful, a Backwash sequence should
occur.
5.2 12v DC Power Adapter
5.
Plug the power adapter (supplied) in to a 110v ac outlet (if outlet is outdoors a 4 gang weather protected GFCI should be used)
6.
The controller will come to life. It goes to sleep quickly, holding down any of the three lower buttons for a few seconds wakes it
back up.
7.
Press the far right (M) button on backwash controller to test that the installation has been succesful, a Backwash sequence should
occur.
Piston
Filter assembly
1.
O-ring
2.
3.
1.
2.
3.
