RAIMONDI PIKUS 105, Руководство пользователя

Страница: 13 / 20

ENGLISH PIKUS 105/105DL – PIKUS 75/75DL
13
Replacing the diamond disk
•
Remove the plastic spray guard.
•
Loosen the screws and remove the disk guard.
•
Insert an Allen wrench into the hollow on the
flange-holder shaft.
•
Loosen the disk securing nut with the supplied 22
mm Allen wrench, turning it clockwise.
•
Install the diamond disk, following the direction of
rotation indicated on the disk and on the disk
guard.
•
To ensure that the disk is firmly secured in place,
tap on the shaft of the 22 mm Allen wrench with a
hammer.
•
Refit the disk guard.
•
Manually rotate the disk to check that it has been
installed correctly
.
ATTENTION: DO NOT FORGET TO
REFIT THE SPRAY GUARD.
SHARPENING THE DIAMOND DISK
SHARPEN THE DIAMOND DISK BY RUNNING A FEW CUTS AGAINST THE DISK
SHARPENER.
Regulating the slide device
Set the motor head to its low position.
If the motor head shows excessive play, proceed as
follows:
•
Loosen the nut (A).
•
Adjust by means of the screw (B).
•
Tighten the nut (A).
F
IG
. 13
F
IG
. 14
B
A