© Raimondi S.p.A.
MANUALE D’USO E MANUTENZIONE
PAG.X DI XX
mod. BOLT - ED. 03/2015 - S. 01
Page 18/36-4
CHAPTER 4
Use of the Commands
raimondispa.com
Via dei Tipografi 11, 41122 Modena (MO) - Italy
Tel.: +(39) 059 280888 - Fax: +(39) 059 282808
4.1 Cutting
During cutting, advance speed shall be proportionate to the hardness and thickness of the material to be cut, in order to avoid flexure or distortion
of the blade and motor overload.
Push the starting switch, wait until cooling water of the diamond blade has come out.
Start cutting slowly approaching the diamond blade to the material to be cut. Go on cutting keeping a constant advancement speed, slowing
down when close to the end of cutting.
In case of breaking of the end part of the tile (last centimeter) sharpen the diamond blade making some cuts with the dressing stone.
If the problem is not solved, comply with the following:
make a cut of about 2 cm (25/32”) on one side of the tile, turn it and make the cut until you reach the 2 cm (25/32”) cut previously made.
1
2
3
2 cm (25/32”) cut
Complete cut
180°
BEFORE CUTTINg, MAKE SURE
THE UPRIgHT LOCKINg KNOB
(A) AND LIFT LOCKINg KNOB (B)
HAvE BEEN SCREWED TO THE END
OF TRAvEL AND THAT CUTTINg
LINE /SQUARE ALIgNMENT IS
COMPRISED WITHIN THE TOLE-
RANCE RANgE ± 1,5 MM (1/16”)
PER METER.
B
A
IN CASE OF CUTTINg OF THICK MATERIALS, IT IS ADvISABLE THAT CUTTINg IS MADE IN SEvERAL PASSES
ACCORDINg TO THE HARDNESS OF THE MATERIAL.
DURINg THE CUTTINg OPERATION, COMPLY WITH THE INSTRUCTIONS IN THE “OPERATOR POSITION” PARA-
gRAPH.
vERIFY CLEAN WATER IS IN THE TANK, IN A QUANTITY SUCH THAT THE PUMP IS COMPLETELY SUBMERgED - SEE
PARAgRAPH “5.5 TANK CLEANINg”. TURBID WATER CAN CAUSE MALFUNCTIONINg OR BREAKINg OF THE PUMP.
