1
CROSSBEAM
KICKSTAND
Slip the bottom of the kickstand into the inside
of one of the crossbeams.
2
Pull kickstand completely through and ensure
the pins in the kick stand base insert into the
indentions on the inside of the Crossbeam.
3
Bring the other side of the crossbeam to meet up
against the kickstand side.
4
Compress both sides of the crossbeam and
you should feel a click as the cross beam pins
fit into the opposite side.
5
6
Swivel the
Hull Rail into
the hook.
7
Install straps as shown on back of instructions and
you are ready to use your C-TUG R.
9
Continue to swivel the rails until they are flat.
Position the Rails of your C-Tug to match
your kayak hull and tighten bolts.
8
CLICK TO
LOCK
Slip the wheel over the axle and push down on
axle pin till it clicks into the lock position.
Assembled C-Tug rails
1. Insert nuts into hex
recess through the
C-TUG Rails
2. Add green D-washers
over bolt, flat edge
against bracket
3. Tighten by hand
4. Press on green pads.
