Set Up
Connect the red wire to the AC hot on your transformer, and the black wire to the ground on the transformer.
Operate between 12 and 18v.
Wiring Instructions
Smoke Unit
Remove cap from roof marked “S” and a
dd 15-20 drops of smoke fluid through the smokestack before running.
We recommend M.T.H. ProtoSmoke, Seuthe or LGB fluids. Do not overfill the unit or the fluid may leak out and coat the
interior components. Failure to add fluid to the unit may damage the smoke unit heating element and/or wicking material.
THIS ACCESSORY CANNOT RUN WITHOUT FLUID IN THE SMOKE UNIT.
Remove cap from roof marked “W” and pour 1/4 cup water into water fill area (clear plastic pool). Do not over fill.
(The factory can function without water - the pump will not burn up).
To drain water, pull the rubber drain plug located on bottom of factory.
(Please note that the figure must be elevated above the water pool. If not, gravity will force water through the hose).
Adding Water
Smoke Unit
Drain Plug
Water Fill Area
Water Fill Smoke Fill
AC
ACG
