CABLE CURVES
UPWARD
6
Checking the Battery
You may find, if your set was built several months before you set it up, that the
rechargeable battery has run down and needs to be charged before operating. If you
notice that the sounds are garbled, test and charge the engine as described in the "Self-
Charging Battery Back-Up" on page 16.
Remote Control
The remote and lock-on are designed for use with moderate power supplies such as the
one included with this set. It is compatible with virtually any manufacturer's engines.
®
Note:
The RailKing Remote Control and Remote Lock-on will not operate engines
®
™
™
equipped with pre-1997 versions of Proto-Sound or with Proto-One, Proto-Plus,
™
Proto-Deluxe, aftermarket systems.
!
Plug tender plug into boiler socket at the back of cab.
!
Connect the draw bar between the engine and tender.
DO NOT CONNECT
This Engine To A
Tender From
Another Engine; It May
Cause Serious Damage.
Look at the bottom of the
engine and tender where
each will have a color-coded
stamp. If they match you
may connect those two
pieces; if not, don't.
Insert two AA batteries (not
included) into the remote.
Green LED flashing
indicates lock-on is
receiving signals from
remote.
Controls trains from
up to 15 feet from
the lock-on.
Aim remote control at the
rounded side of the lock-on
sensor to send track. Lock-
on sensor can be rotated to the
direction you will most often
signal.
Remove phillips screw with
screwdriver on back of remote.
STEP
1
1
STEP
2
2
STEP
3
3
STEP
4
4
STEP
5
5
RailKing 6-8-6 Bantam Turbine Steam Passenger Set with Proto-Sound® 2.0
