Self-Charging Battery Back-Up
The special NiCad 2.4v self-charging battery pack recharges continuously during train
operation and should last for up to five years. The battery is a dry battery that should not
leak or cause any damage to your engine.
Depending upon when your engine was
built, it may need to be charged right out of the box.
If engine sounds seem distorted
or garbled at low voltages or become silent when power from the transformer is turned
off, test the battery to determine whether it should be recharged or replaced.
!
Test:
Put the engine in neutral and leave the track voltage at 10-12 volts (high
enough for the lights to shine brightly and the engine to move steadily) for 15
minutes.
!
Recharge:
If the sounds are improved at the end of the 15-minute test charge, the
battery charge has run down and can be recharged. There are a number of ways you
can do this:
!
Leave the engine in neutral with track voltage at 10-12 volts for 6-7hours so
the battery can fully recharge (if your engine has a smoke unit, be sure it is
turned off).
!
Use M.T.H.'s battery recharger (sold separately) that plugs into a wall outlet and
a special port under the tender to recharge the battery overnight without leaving
it on the track.
!
Replace:
If the sounds are not improved at the end of the 15-minute test charge, it is
time to replace the batt
ery. Available through M.T.H. Parts. See parts list in this
manual, or on M.T.H.’s website www.railking.com.
16
RailKing 2-8-0 Steam Freight/Passenger Set with Proto-Sound® 2.0
Battery Charger
Item No. 50-1019
Unhook wires, Remove
and Replace Battery
Carefully loosen the
end frames on both
ends from the step
platform.
Then grasp the end
frame by the bottom
and pivot outward 5
degrees. Remove
the step platforms
from both ends.
Lower the
chassis from
the shell,
taking care not
to pull the
wires out.
Step Platform
End
Frame
STEP
3
3
STEP
4
4
Bayonet Bulb
(Part #CI-0000015)
1
2
Replace a Bayonet Bulb by turning and
pushing up, pulling the bulb from its socket.
STEP
5
5
