12
Use the female end of a standard 3-pronged power cord.
7) Plug the power supply cable into the wall outlet and verify power
The red LED will illuminate when power is on.
8) Plug in the PC (if necessary) and turn it on
9) Launch the desired host software application
•
You may use Raifu’s demo application software or custom software
developed per the reader-host protocol for your specific application.
Y
ou are now ready to bench test or demonstrate the RFID Reader system.
2.3.2 Bench Test Configuration for Network
1) Situate the Reader on a tabletop
Ensure the following conditions:
•
Two standard 220 VAC outlets are available nearby (one for the reader,
one for the PC if needed).
Sufficient space is available on the tabletop for the PC, reader and antenna.
Figure 2.7 – RJ45 and Power Connections
2) Connect the RJ45 able to the reader.
•
Align the male cable connector so that its shape and pins match the shape
and holes of the RJ45TCP/IP port.
•
Push the aligned connector into the port.
•
Finger-tighten the screws to secure the cable/connector to the reader.
Figure 2.8 – RJ45Connector
3) Connect the RJ45 cable to the Net port on the PC
