Raidon SAFETank Series, Руководство пользователя

Страница: 19 / 49

GR5640 User Manual
17
8.
Replacement of Malfunctioning Drive and Data Rebuild Instructions
9. System Temperature Overheat and Fan Failure Management
1. Remove the drive tray containing the malfunctioned hard drive and disassemble the hard drive
from drive tray.
2. Mount the new hard drive onto the tray and insert it back to the empty drive position of the
GR5640, then push the latch into place making sure it is secured and locked.
3. In RAID 5 mode, when you turn the system on, the hard drive status indicator of the replacement
drive will interchangeably blink red and purple to inform that the data is being rebuilt to the
replacement drive. During data rebuild, you may operate the GR5640 as normal. When the
indicator stops, the data rebuild process has been completed.
If the alarm indicator has lit up red and the audio alarm sounds, this could mean that either a
system fan has stopped operating entirely or the system temperature has exceeded over the default
temperature of 55 ° C. When this occurs, you may press the mute button at the rear of the system to
shut off the audio alarm and power off the system immediately if in the allowed operational state to let
the system cool. Check and see if the overall operation environment is well ventilated and make sure
there are no blockages to the enclosed fan and then re-power on the system to continue use. If the
problem persists, please turn off the system and contact your supplier or the RAIDON tech support
for further assistance.
When a front hard drive indicator has lit up red and the audio alarm sounds, this could mean the
indicated hard drive may be malfunctioning. If this occurs, you may press the mute button at the
rear of the system to shut off the audio alarm and power off the system immediately if in the allowed
operational state, and then re-power on the system to double check and see if in fact the indicated
hard drive has malfunctioned. If the problem persists, please turn off the system and follow the
directions below :