Raider RD-HP04, Руководство пользователя

Страница: 7 / 50

7
1. Functional Description and purpose
Hydraulic Press Raider is a machine that works on the principle of hydraulic pressure with a
capacity of 20 T. It can be used for pulling and piling bearings, bushings, pads and more.
2. Safety instructions
Read all instructions. Failure to follow the instructions may lead to serious injury. Keep these
instructions in a safe place.
• Do not use the compression springs and other details that can bounce off and cause injury.
• The hydraulic press must also be used by skilled workers. Keep the unit clean to ensure its
safe operation and quality performance.
• Do not exceed the capacity of the press. Never use excessive force to detail.
• Use the press by purpose. Do not use it for activities for which it is not suitable.
• Keep children and unauthorized to work with the press people away from the working area.
• Remove yourself from clothes that are torn, ties, watches, rings and the like, and gather long
hair if you have one.
• During operation wear approved by the relevant standard protective equipment glasses,
protective face mask and gloves.
• Maintain a steady position by wearing appropriate work shoes, do not wear open shoes.
• Always use the press on a solid, level, dry, anti-slip and able to withstand the load surface.
• Inspect for defects before each use. Do not use the press when it is scratched, broken,
damaged, leaks or other damage.
• Check to make sure that the product you‘re working on and centered and secured.
• Check and make sure that all bolts and nuts are tightened.
• Keep your limbs away from moving parts.
• Do not use the press for the compression of springs and the like, which may escape and
cause potential accidents. Never stand directly opposite the busy press and leave loaded press
unattended.
• Do not use the press when you are tired or under the influence of alcohol, narcotics or drugs,
medical drugs with warnings about possible side effects.
• Do not allow untrained people to work with the press.
• Do not make any modifications to the press.
• Do not use brake fluid or similar liquids other than hydraulic oil. Only hydraulic oil of good
quality can be used.
• Do not expose the release of rain and other adverse weather conditions.
Attention! These warnings and instructions do not cover any unexpected conditions and
situations that may arise. The operators must understand the need to work with caution and in
good condition to avoid possible risks.
3. Installation.
Note: In connection with the weight and size of components, assembly of the press must be
performed by at least two people. Safe installation can not be achieved by one person.
Use Scheme 1 to navigate the installation.
• Install supine legs (4) to the base (6) and secure it with nuts and bolts with washers
• Straighten both legs and the assembled insert pads (5) and the stabilizing plate (11) to attach
with nuts and bolts with washers
• Place the lower base of the press (7) attach it to a fixed support (9).
• Raise the so assembled press, so to fix the piston in the upper part and the upper basis (6)
using the locking ring (12) and fasten manomentara to the piston by means of „O“ ring
• Place the lower base (7) of the desired height with the aid of fixing struts (9) and put on their
pads (8). Secure the hydraulic pump plate.
• bolt located on the other side of the valve release (13) serves as a topping with hydraulic oil
and its replacement. Be careful while topping up or changing the oil, it does not fall dust or other
contaminants. Recommended hydraulic oil viscosity grade 10 SAE.
Note: Do not tighten the screws tight until the installation is not completed final.