Raider RD-ESH02, Руководство пользователя

Страница: 20 / 86

20 www.raider.bg
9.1. Insert the power cord so that it does not interfere with work and prevent damage.
9.2. Keep the cable away from heat, corrosive liquids and sharp edges.
9.3. When disconnecting the plug, do not pull it from the cord.
9.4. If the service cable is defective, have it replaced by an accredited service center, yes
prevent danger
9.5. Do not carry or pull the machine through the service cable or pull the socket outlet from the socket
by pulling the cable. Protect the service cable from heat, grease and sharp edges.
10. UNPACKING
10.1. Carefully remove the product from the box.
10.2. Carefully check all parts. If any part is damaged or missing, contact your dealer or an authorized
service center.
10.3. Do not dispose of packaging materials until you have carefully inspected for any remaining parts
of the product.
10.4. Parts of the packaging (plastic bags, paper clips, etc.) that are left in a place easily accessible by
children can be a source of danger. There is a risk of swallowing or suffocation!
10.5. Disposal must be made in accordance with the regulations in force in the country where the
equipment is installed.
10.6. Make sure bags and containers of plastic are not loose in the environment because they are dirty.
10.7. If in doubt, do not use the machine, but have it checked by an authorized service center.
This product requires installation. The device must be properly installed before use.
11. INSTALLATION
11.1. Turn the bobbin crusher upside down and rotate the legs up.
11.2. Insert the axle connecting wheels through the corresponding holes.
11.3. Place the washer and bushing on the wheel axis.
11.4. Replace the wheels and insert the nut, tighten them by hand.
11.5. Use the hex wrench (hexagon) provided to secure the wheel axle, and at the same time securely
lock the nut using the wrench.
11.6. Finally, place the wheel cover in the center of the wheel.
CAUTION: Be careful when mounting the appliance on its wheels, as it has an uneven weight
distribution when tilting and transporting.
12. USE
12.1. COMMISSIONING
Make sure that the mains voltage is consistent with the label data. Use an extension cable to connect
your device (the extension cable is not included).
12.2 ON / OFF
ATTENTION! Make sure the mains voltage matches the label data. The crushing hole must be empty.
• Connect the extension cable.
• Set the rotary direction switch to the raised position.
• To turn on, press the ON button.
• To switch off, press the OFF button.
12.3. ADJUSTING THE DIRECTION OF DIRECTION
Always switch off the machine and wait until the crusher has stopped rotating before changing the
direction of rotation.
Unloaded position
Set rotary direction switch to unloaded position (suction position; continuous operation position): the
material is pulled and crushed.