Raider RD-ESC01, Руководство пользователя

Страница: 15 / 86

15
1. PREPARATION
1.1. Always wear work shoes and long pants while operating the machine. Do not operate the
machine barefoot or in open sandals. Do not wear clothing that has loose parts or hanging ties or
ties.
1.2. Always use effective safety goggles and safety goggles.
1.3. Carefully check the area where the machine will be used and remove any objects that the
machine may throw away.
1.4. Before starting the machine, make sure that all bolts, nuts and other fasteners are properly
tightened and that the fuses and shields are in the correct place. Replace damaged or illegible
labels.
1.5. Check the power supply and extension cable for signs of damage or aging before use. If
the power supply is damaged during use, immediately turn off the power. Do not touch the power
before turning off the power. Do not use the machine if the power supply is damaged or worn.
1.6. The cable drum is fully expanded before being fully used. Only use extension cords with
sufficient sections approved for this purpose and labeled accordingly.
Note: It is a good idea for the extension cable to be distinctive in order not to overlook, cut,
cut or cut it.
• Use the machine in the recommended position and only on a firm, level surface.
• Do not operate the machine on a surface with pavement or gravel, where discarded material
may cause injury.
2. USE
2.1. Use the machine only in daylight or in good artificial light.
2.2. Avoid using the machine on wet grass.
2.3. Make sure you always have a stable slope position.
2.4. Always walk, never run with the machine.
2.5. Work on the slope, never up and down.
2.6. Move very carefully if you change the direction of the slope.
2.7. Do not operate the machine on slopes that are too steep.
2.8. Take special care if you pay or pull the machine towards you:
Stop sharp edges if the machine is to be tilted when passing through a surface other than grass
and when the machine is being transported to or from the cutting area.
Never operate a machine that has defective protective covers or fuses or does not have safety
devices such as deflectors and / or a collection basket.
2.9. Start the engine carefully in accordance with the operating instructions and stay away from
sharp edges.
2.10. Do not tilt the machine when starting the engine unless the machine has to tilt at startup.
In this case, do not tilt it more than necessary and only lift the part that is away from you. Always
keep both hands in working position before placing the machine back on the ground.
2.11. Do not start the machine when facing the drilling hole.
2.12. Do not place your hands or feet near or under rotating parts. Never stand before the
drilling hole.
2.13. Do not carry the machine while the engine is running.
2.14. Stop the machine and remove the plug (and remove the locking device, if installed). Make
sure that all moving parts are completely stopped.
- every time you leave the machine,
- before cleaning a clogged duct,