10
www.raider.bg
that cannot be controlled with the switch is dangerous and must be repaired.
1.4.3. Disconnect the plug from the power source and/or the battery pack from the power
tool before making any adjustments, changing accessories, or storing power tools. Such
preventive safety measures reduce the risk of starting the power tool accidentally.
1.4.4. Store idle power tools out of the reach of children and do not allow persons unfamiliar
with the power tool or these instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
1.4.5. Maintain power tools. Check for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the power tool’s operation. If damaged, have
the power tool repaired before use. Many accidents are caused by poorly maintained power
tools.
1.4.6. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
1.4.7. Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be performed. Use
of the power tool for operations different from those intended could result in a hazardous
situation.
2.
BEFORE USING THE MACHINE
MAINS VOLTAGE
Ensure that your mains voltage agrees with the information printed on the machine’s rating
label Ensure that the machine is switched off before connecting the machine to the mains.
The machine may only be connected to a properly earthed mains socket.
FITTING THE TIPS
Caution! Disconnect the machine from the mains.
Proceed as follows to change the tips:
- Disconnect the machine from the mains.
* Loosen the removable tip locking screw
(A) using the hex key (B) provided.
- Insert the required tip in the collet (C) as
far as it will go.
■ Tighten the removable tip locking screw (A).
Do not overtighten
3.
USING THE MACHINE
SWITCHING ON / OFF
Turning the machine on
■ Put the ON/OFF switch in the T position.
Turning the machine off
* Put the ON/OFF switch in the ‘O’ position