Raider RD-CDD04, Руководство пользователя

Страница: 12 / 74

12 www.raider.bg
9.2. Adjusting the Speed.
The speed of the switched on power tool
can be variably adjusted, depending on how
far the On/Off switch (1) is pressed. Light
pressure on the On/Off switch (1) results in a
low rotational speed. Further pressure on the
switch results in an increase in speed.
Corded Drill Drive allows for operation with
different spindle speeds. It can be controlled
with the On/Off switch (1). The speed can
also be smoothly adjusted by increasing or
decreasing of pressure on the switch button
(1).
Reduce the speed by turning the wheel (3)
counter-clockwise.
9.3. The right choice of the speed is when
screwdriver is included without load. Preset
speed when handling loads may be lower.
9.4. Reversing the rotational direction.
The rotational direction switch (3) is used
to reverse the rotational direction of the
machine. However, this is not possible with
the On/Off switch (1) actuated. Right rotation:
For driving in screws, push the rotational
direction switch (3) left to the stop. Left
rotation: Push the rotational direction switch
(3) right to the stop (for unscrewing screws).
9.5. Overload clutch. Torque control.
Setting the ring (4) in given position causes
permanent setting of the clutch to specified
torque. When the set torque is reached,
overload clutch releases automatically. It
prevents screwing screws t deep or damaging
the drill.
Different screws and materials require
different torque to be applied.
The bigger number corresponding to given
position, the bigger the torque.
Set the ring (4) to specified torque.
Always start operation with low torque.
Increase the torque gradually until
appropriate value is set.
Use higher settings to unscrew screws.
10. Working with Corded Drill Drive.
10.1. Insert bit in the head of electric
Corded Drill Drive. Screwdriver shaft should
not rotate. Press the tip of the screw firmly
to detail, which will wrap and press trigger
switch (1). Drive the shaft is interrupted by
the clutch and he stops spinning. Check the
depth of turning the screws and adjust it if
necessary.
10.2. To unscrew put to switch direction of
rotation (3) in position “turning left”.
Do not throw the power tool and do not
overload.
Keep and refer to the accessories carefully.
Make periodic breaks at work.
11. Service and Support. Before any work
on the machine itself, pull the mains plug.
11.1. Never use water or any liquid
chemical for cleaning Corded Drill Drive. It
should be cleaned with a piece of dry cloth
and remove the accumulated dust with a soft
brush. Always keep Corded Drill Drive in a dry
place and keep the machine and ventilation
slots clean.
11.2. Replacing the carbon brushes. Worn-
out (shorter than 5 mm), or broken carbon
brushes of the engine should be replaced.
Always replace both the two brushes. Work
on replacement of carbon brushes entrusted
only to qualified specialists with original
spare parts in service of RAIDER.
11.3. The repair of your power tool is best
carried out only by qualified specialists in
service RAIDER, which used only original
spare parts. Thus ensuring their safe
operation.
12. Preservation of the environment.
In view of environmental
power, additional accessories and
packaging must be subjected to
appropriate processing for reuse of
the information contained in these
materials.
Do not dispose of electric household
waste! Under the EU Directive 2012/19/EC
on waste electrical and electronic devices
and validation and as a national law power
which can be used more, must be collected
separately and be subjected to appropriate
processing for recovery of contained they
scrap.