Raider RD-AW03, Руководство пользователя

Страница: 11 / 62

11 RAIDER POWER TOOLS
in the area of the air inlet), remove the strainer and clean it.
5. When not in use, disconnect from air supply, clean tool and store in a safe, dry, childproof location.
Trouble Shooting
The following form lists the common operating system with problem and solutions. Please read the form
carefully and follow it.
WARNING: If any of the following symptoms appears during your operating, stop using the tool
immediately, or serious personal injury could result. Only a qualified persons or an authorized service center
can perform repairs or replacement of tool.
Disconnect tool from air supply before attempting repair or adjustment. When replacing O-rings or
Cylinder, lubricate with air tool oil before assembly.
PROBLEMS POSSIBLE CAUSES REMEDIES
Tool runs at normal speed but loses under
load
■. Motor parts worn.
■ Cam clutch worn or sticking due to lack of
lubricant.
■ Lubricating clutch housing.
■ Check for excess clutch oil. Clutch cases
need only be half full. Overfilling
can cause drag on high speed clutch parts, ie.
a typical oiled/lubricated wrench requires 1⁄2
ounce of oil.
GREASE LUBRICATED:NOTE: Heat usually
indicates insufficient grease in chamber.
Severe operating conditions may require more
frequent lubrication.
Tool runs slowly. Air flows slightly from
exhaust
■ Motor parts jammed with dirt particles
■ Power regulator in closed position
■ Air flow blocked by dirt.
■ Check air inlet filter for blockage.
■ Pour air tool lubricating oil into air inlet as
per instructions.
■ Operate tool in short bursts quickly reversing
rotation back and forth where applicable.
■ Repeat above as needed. If this fails return
to service centre.
Tools will not run. Air flows freely from
exhaust
■ One or more motor vanes stuck due to
material build up.
■ Pour air tool lubricating tool into air inlet.
■ Operate tool in short bursts of forward and/
or reverse rotation where applicable.
■ Tap motor housing gently with plastic mallet.
■ Disconnect supply. Free motor by rotating
drive shank manually where applicable
■ If tool remains jammed return to service
centre.
Tool will not shut off
■ ‘O’ rings throttle valve dislodged from seat
inlet valve.
■ Replace ‘O’ ring or return to service centre.
Note: Repairs should be carried out by a qualified person.