Raider Pro RDP-WP25, Инструкция по эксплуатации

Страница: 29 / 62

29
any injuries as a result of interference do
not use the pump before they renovated.
Important! Repair required should be per -
formed by a qualified electrician.
applications:
Submersible pumps are used for fixed
installation in wells and other passive
reservoirs.
Proper use
The equipment you have
purchased is designed to pump
water with a maximum tem -
perature of 35 °C.
This equipment must never be used for
other liquids, especially engine fuels, clean -
ing agents and other chemically-based
products! Installed in a shaft, the equipment
provides protection from flooding.
However, it can be used wherever you want
to move water, e.g. in the house, in the
garden, and for many other applications.
The equipment must not be used to operate
swimming pools!
If you want to use the equipment in bodies
of water with a natural, muddy bottom,
place the equipment in a slightly elevated
position, e.g. on bricks.
The equipment is not designed for continu -
ous operation, e.g. as a circulating pump
in a pond. In this case the equipment’s
anticipated life will be greatly shortened
because the equipment was not designed
for continuous loading.
The equipment is to be used only for its pre -
scribed purpose. Any other use is deemed
to be a case of misuse. The user / operator
and not the manufacturer will be liable for
any damage or injuries of any kind caused
as a result of this.
Please note that our equipment has not
been designed for use in commercial, trade
or industrial applications. Our warranty will
be voided if the machine is used in com -
mercial, trade or industrial businesses or for
equivalent purposes.
Layout (Fig. 1)
1. Handle
2. Universal hose connection
3. Intake cage
4. Floating switch
Before putting the equipment into
operation
Installation
The equipment can be installed either:
Stationary with rigid tubing or
Stationary with a flexible hose line
Note:
The maximum pumping rate is possible
only with the largest possible line diameter;
if smaller hoses or tubes are connected, the
pumping rate will be reduced. If the univer -
sal hose connection (Fig. 1/Item
2) is used, it should be shortened.
to the connection actually used in order not
to reduce the pumping rate unnecessar -
ily. Flexible hoses must be fastened to the
universal hose connection with a hose clip
(not included in the scope of supply).
Note!
When installing, never hang the equipment
by the discharge line or by the power cable.
The equipment must be hung up with the
provided carry handle or it must rest on
the bottom of the shaft. To ensure that the
equipment works properly, the bottom of
the shaft always must be free of sludge
and other accumulations of dirt. If the water
level is too low, the sludge in the shaft can
quickly dry out and hinder the equipment
from starting. It is necessary therefore to
check the equipment regularly (carry out
trial startups).
Note:
The pump shaft should measure at least
40 x 40 x 50 cm so that the floating switch
can move freely.
Mains connection
The equipment you have purchased comes
with an earthing-pin plug. The equipment is
designed for connection to a socket outlet