Raider PRO RDP-CDLGP02, Руководство пользователя

Страница: 30 / 64

30 www.raider.bg
order to avoid one-sided wear due to friction, it is recommended to turn the bar at each sharpening of
the chain. At the same time, the spout in the rail and the oil holes must be cleaned. The rail groove has
a rectangular shape. Check the chute for wear. Glue a measuring line or a smooth flat object to the
guide bar and the outer surface of a chain tooth. If you notice a gap between them, it means that the
gutter is OK. Otherwise the tire is probably worn and needs to be replaced.
Guide gear.
The drive gear is an element that is particularly susceptible to wear. If visible signs of wear on the
sprocket teeth are noticed, it must be replaced. The worn sprocket further shortens the durability of
the saw chain. The sprocket must be replaced by an authorized workshop.
Saw chain tension.
During operation of the garden pruner, the cutting chain lengthens due to heating. The stretched
chain loosens and can be released from the guide rail.
Check that the chain (8) is located in the bushing (7).
Check the chain tension again. The chain should be able to be lifted from the upper end of the rail to
a height of about 3-4 mm.
The chain should not be tightened too much. Adjustments made with a very hot circuit can lead to
excessive tension after cooling.
Working with the cordless garden pruner
Before proceeding with the planned work, you should familiarize yourself with the points containing
the rules for safe work. It is recommended that you first practice cutting unnecessary pieces of wood.
This will help you get to know the capabilities of the machine in more detail.
You should always follow the safety rules.
The cordless garden pruner can only be used for cutting wood. It is not allowed to cut other materials
with it.
The intensity of the vibrations and the effect of the bounce are different when cutting different types
of wood.
The use of the machine as a lever for lifting, moving or dividing objects is not permitted. In the event
of a chain jam, the engine must be switched off and a plastic or wooden wedge driven into the cut-out
to release the garden pruner. Then turn on the garden pruner again and carefully start cutting.
You do not need to press hard on the garden pruner when cutting. There should be only a little
pressure when the garden pruner is running at maximum speed.
If the garden pruner gets stuck in the slot during cutting, you should never pull it by force. This
may result in loss of control of the garden pruner and injury to the operator and / or damage to the
garden pruner.
Wait until the engine reaches maximum speed before cutting.
Maintain high speeds during operation.
Let the chain cut the wood. Push the garden pruner only slightly down.
In order not to lose control, you must stop pressing the garden pruner at the end of the operation.
Bounce protection.
“Bounce” means the movement of the guide rail of the saw chain up and / or backwards, which can
occur when the saw chain with its front part rests on an object.
You need to make sure that the workpiece is firmly attached. Use clamps to secure the material.
You must hold the garden pruner firmly when switching on and during operation. When bouncing,
the garden pruner is out of control and the chain may become loose.
Improperly sharpened chain increases the risk of bouncing.
You should never cut at a height higher than the shoulders.
Cutting with the front of the bar should be avoided, as this can cause the garden pruner to bounce
back and forth suddenly. When working with the garden pruner always use full equipment as well as
the appropriate work clothes.
Disassembly of safety devices, improper maintenance, maintenance, or improper replacement of the
guide rail or chain can increase the risk of personal injury in the event of a bounce. It is not allowed
to perform any reconstructions of the garden pruner. In case of using an arbitrarily reconstructed
garden pruner, the user loses all rights arising from the warranty. Loss of warranty may also result
from the use of the garden pruner in violation of the information contained in this manual.
Cutting with the machine.