Raider Outboards Raider Series, Руководство пользователя

Страница: 54 / 58

Appendix Alfa
Owner’s Manual Pre and Post Operations Checks
45
f. Fuel Filter
•
Inspect component for leaks, damage, or excessive wear.
•
Inspect Clamps: Ensuring proper fit, note leaks, damage, or
excessive wear.
•
Inspect Lines: Check for dry rot and chaffing.
f.
g. Fuel Pumps
•
Inspect component for leaks, damage, or excessive wear.
•
Inspect Clamps: Ensuring proper fit, note leaks, damage, or
excessive wear.
•
Inspect Lines: Check for dry rot and chaffing.
g.
h. Carburetors
•
Inspect component for leaks, damage, or excessive wear.
•
Inspect Clamps: Ensuring proper fit, note leaks, damage, or
excessive wear.
•
Inspect Lines: Check for dry rot and chaffing.
h.
i. Primer
•
Inspect for damage due to corrosion, lack of maintenance, or
abuse. Loose ball joints, locknuts, bent link rods, loose rod snaps.
•
Lubricate with Friction Surface Marine Grease.
i.
Operational Checks
Completed
(initial)
a. Pull Start
•
Start the motor using the recoil starter.
a.
b. Electric Start
•
Start the motor using the electric start push button. b.
c. Neutral Safety
•
Verify that the motor will not start in gear both forward and
reverse.
c.
d.
Water discharge from
check ports
•
When the motor is running verify that water is being discharged
from all check ports.
d.
e. Tiller Steering
•
When moving the Tiller Arm, verify that the motor moves freely
to port and starboard.
e.
f. Neutral
•
Verify the propeller does not engage when the gear selector is in
the neutral position.
f.
g. Forward
•
With the motor at idle, verify the Gear Selector moves freely into
the forward position and the propeller engages.
g.
h. Reverse
•
With the motor at idle, verify the Gear Selector moves freely into
the reverse position and the propeller engages.
h.
i. Throttle Control
•
With the engine in neutral, slowly increase the throttle RPM’s to
approximately.
i.
j. Emergency Stop Switch
•
While the motor is running, remove the lock plate, the motor
should stop.
j.
k. Engine Stop Switch
•
While the motor is running, press the Engine Stop Switch, the
motor should stop.
k.
l. Shallow Water Running
•
Move the motor Reverse Lock Lever to the release position, lift
the lower unit past a 45° angle until the tilt stopper assembly
locks.
l.
m. Full Tilt Position
•
Move the motor Reverse Lock Lever to the release position, lift
the Lower Unit past a 90° angle until the tilt stopper assembly
locks.