Rage STINGER GPS, Инструкция по эксплуатации

Страница: 11 / 16

11
After unlocking (as shown on the left), short press the take-off/landing button or click the take-off icon on the app
interface and the aircraft will take off.
Do not hold this button in place as it will initiate an Emergency Stop and the motors will turn off in flight!
1. One Button Take-off
When the aircraft needs to land, short press the auto take-off/land button again. The aircraft will automatically land on
the ground in place. During the descent, the direction of flight can be controlled by the control sticks. If you decide you
want to continue to fly instead, press the auto take-off/landing button again, and the descent will stop.
Do not hold this button in place as it will initiate an Emergency Stop and the motors will turn off in flight!
2. One Button Landing
COMPASS CALIBRATION
GYRO CALIBRATION
ACQUIRING GPS SIGNALS
ONE BUTTON TAKE-OFF/LANDING
Short press the one key compass With the body of the drone horizontal
to the ground, rotate the drone through
at least one full turn until the unit beeps
and the blue lights turn solid.
Next, with the nose of the drone pointed
to the sky, rotate the drone until the unit
beeps and the red lights begin to flash.
Then, set the drone on the ground and
when the red lights go solid this step is
complete.
calibration button as shown and the
transmitter will beep. The front and
rear lights of the aircraft should then
turn off.
Short press the Gyro Calibration button and you will hear a beep and the back
red lights will begin to flash. When you hear a 2nd beep, the gyro has been
calibrated. The rear red lights will continue to flash slowly until GPS signals
have been acquired.
Important Note - it is recommended that both the compass calibration
and gyro calibration are completed before flight each time the battery is
installed.
Place the drone on a level space in a clear, unobstructed outdoor surface so the drone can acquire GPS signals. This
step may take 1 to 3 minutes. When the necessary GPS signals have been acquired, the rear red lights will stay on solid
and the transmitter will beep once. This process of acquiring satellites can be monitored by viewing the top of the app
screen on your device (see page 13).
Note: If this process has not been completed after 3 minutes, the required number of satellites to fly with GPS
have not been acquired. Either search for a more unobstructed setting to try acquiring signals again or long
press the GPS On/Off button on the transmitter (see page 5) until the GPS light goes off to fly without GPS.
The motors can then be unlocked by following the instructions in the following section.
Ground