background image

Safety Precau  ons

As the owner and user of this product, you are 
solely responsible for opera  ng it in a manner 
that does not endanger yourself and others or 
result in damage to the product or property.
•  Be cau  ous with the propellers when the 

motors are running. Do not come into contact 
with rota  ng propellers as serious injury 
could result.

•  Keep a safe distance, in all direc  ons, around 

your aircra   to avoid possible collisions or 
injury. This aircra   is controlled by a radio 
signal that is subject to interference from 
many outside sources and could result in a 
momentary loss of control.

•  Always avoid water exposure to all equipment 

not specifi cally designed and protected 
for this purpose. Moisture can damage 
unprotected electronics.

•  Make sure to keep all chemicals, small parts 

and anything electrical out of the reach of 
children.

Age Recommenda  ons

This product is not a toy. Not for use by children 
under 14 years of age.

Ba  ery Safety Precau  ons

Important Note

: Lithium Polymer (LiPo) 

ba  eries are more vola  le than the alkaline, 
NiCad and NiMH ba  eries used in other RC 
applica  ons. All instruc  ons and warnings must 
be followed exactly to prevent possible personal 
injury or damage to property, including by fi re. 
By handling, charging, or using the included LiPo 
ba  ery you assume all poten  al risks. If you do 
not agree with these condi  ons, please return 
your complete product in new, unused condi  on 
to the place of purchase immediately. 

Important

 - Please read the following safety 

instruc  ons and warnings before handling, 
charging, or using the included ba  ery.
•  You must charge you LiPo ba  ery in a safe 

area away from any fl ammable materials.

•  Never charge the LiPo ba  ery una  ended 

at any   me. When charging the ba  ery you 
should always remain in constant observa  on 
of the ba  ery to monitor the process and 
react immediately to poten  al problems you 
observe.

•  A  er discharging the ba  ery during opera  on 

you must allow it to cool to ambient 
room temperature before a  emp  ng to 
recharge. Also, it is NOT recommended 
that you completely discharge the ba  ery 

before charging. It is safe to charge par  ally 
discharged ba  eries when using an 
appropriate LiPo charger.

•  For charging the ba  ery you must use only 

the included charger. Failure to do so may 
result in a fi re causing property damage 
and/or personal injury. DO NOT use a NiCad 
or NiMh charger to charge your new LiPo 
ba  ery.

•  If, at any   me during the charge or discharge 

process, the ba  ery begins to “balloon” or 
swell, discon  nue charging or discharging 
immediately! Quickly and safely disconnect 
the ba  ery before placing it in a safe, 
open area away from fl ammable materials 
for observa  on for at least 15 minutes. 
Con  nuing to charge or discharge a ba  ery 
that has started to “balloon” or swell can 
result in a fi re. Important note: A ba  ery 
that has “ballooned” or swollen even a small 
amount must be removed from service 
immediately and completely.

•  Never discharge a LiPo ba  ery below 3V 

per cell.

•  Always disconnect a ba  ery from the ESC 

when the product is not in use.

•  Avoid con  nually opera  ng the ba  ery to LVC 

(Low Voltage Cutoff ) as this could result in 
damage to the ba  ery.

•  Store the ba  ery par  ally charged 

(approximately 50% charged or 3.85V per cell) 
at room temperature (approximately 68

º

 to 

77

º

 Fahrenheit) in a dry area for best results.

•  When transpor  ng or temporarily storing 

the ba  ery, the temperature range should 
be between 40

º

 and 100

º

F. Do not store the 

ba  ery inside a hot car or in direct sunlight 
or the ba  ery could be damaged or even 
catch fi re.

•  LiPo cells should not be discharged below 

3.0V each. In the case of this 1-cell, 3.7V 
ba  ery you should not allow the voltage to 
fall below 3.0V during opera  on.

•  Do not over-discharge the LiPo ba  ery, doing 

so could result in reduced power, lower run 

 mes or complete failure of the ba  ery.

NOTE

: Your aircra   features a “so  ” LVC (Low 

Voltage Cutoff ) that smoothly reduces power 
(regardless of your thro  le posi  on) to let you 
know the ba  ery is near the minimum voltage to 
avoid damage to your ba  ery.

Содержание NanoCam FPV









Отзывы: