8 / 12
The prop saver keeps the propeller and prop shaft from damage, along with preventing
the electronic components from over current. When the airplane hits any obstacle, the
prop will pop loose and fall from the base. To reinstall the prop, center the forward part
(see diagram) on the motor shaft, and press until you hear a "click" that indicates that
the prop has been reinstalled.
Follow these steps to replace a broken propeller and/or shaft adaptor. You will need a
Phillips screwdriver and needle nose pliers (not included).
1. Remove screw with a Phillips screwdriver and remove the spinner and propeller.
2. Remove shaft adaptor (labeled base on the diagram). If it's too tight, use pliers to help.
3. Replace any broken parts.
4. Reinstall all parts by reversing the installation steps to complete the replacement.
Base
Base
Base
Forward
Part
Forward
Part
Forward
Part
Spinner
Spinner
Screw
Screw
Propeller
Propeller
Motor
Shaft
Prop Saver Instructions
Propeller Replacement
Spinner
Propeller
(RGRA1216)
Each Prop/Spinner set includes the
propeller, spinner and forward part.
See page 10 for specific part
numbers for each airplane.
