Rage FPV ORBIT, Инструкция по эксплуатации

Страница: 2 / 8

Safety Precau ons
As the owner and user of this product, you are solely responsible for opera ng it in a manner that does not endanger
yourself and others or result in damage to the product or property.
•
Be cau ous with the propellers when the motors are running. Do not come into contact with rota ng propellers
as serious injury could result.
• Keep a safe distance, in all direc ons, around your aircra to avoid possible collisions or injury. This aircra
is controlled by a radio signal that is subject to interference from many outside sources and could result in a
momentary loss of control.
• Always avoid water exposure to all equipment not specifi cally designed and protected for this purpose. Moisture
can damage to unprotected electronics.
• Make sure to keep all chemicals, small parts and anything electrical out of the reach of children.
Age Recommenda ons
This product is not a toy. Not for use by children under 14 years of age.
Ba ery Safety Precau ons
Important Note : Lithium Polymer (LiPo) ba eries are more vola le than the alkaline, NiCad and NiMH ba eries
used in other RC applica ons. All instruc ons and warnings must be followed exactly to prevent possible personal
injury or damage to property, including by fi re. By handling, charging, or using the included LiPo ba ery you assume
all poten al risks. If you do not agree with these condi ons, please return your complete product in new, unused
condi on to the place of purchase immediately.
Important - Please read the following safety instruc ons and warnings before handling, charging, or using the
included ba ery.
•
You must charge you LiPo ba ery in a safe area away from any fl ammable materials.
• Never charge the LiPo ba ery una ended at any me. When charging the ba ery you should always remain in
constant observa on of the ba ery to monitor the process and react immediately to poten al problems you
observe.
• A er discharging the ba ery during running the boat you must allow it to cool to ambient room temperature
before a emp ng to recharge. Also, it is NOT recommended that you completely discharge the ba ery before
charging. It is safe to charge par ally discharged ba eries when using an appropriate LiPo charge
• For charging the ba ery you must use only the included charger. Failure to do so may result in a fi re causing
property damage and/or personal injury. DO NOT use a NiCad or NiMh charger to charge your new LiPo ba ery.
• If at any me during the charge or discharge process the ba ery begins to “balloon” or swell, discon nue
charging or discharging immediately! Quickly and safely disconnect the ba ery before placing it in a safe, open
area away from fl ammable materials for observa on for at least 15 minutes. Con nuing to charge or discharge a
ba ery that has started to “balloon” or swell can result in a fi re. Important note: A ba ery that has “ballooned”
or swollen even a small amount must be removed from service immediately and completely.
• Never discharge a LiPo ba ery below 3V per cell.
• Always disconnect a ba ery from the ESC when the product is not in use.
• Avoid con nually opera ng the ba ery to LVC (Low Voltage Cutoff ) as this could result in damage to the ba ery.
• Store the ba ery par ally charged (approximately 50% charged or 3.85V per cell) at room temperature
(approximately 68
º to 77 º Fahrenheit) in a dry area for best result
• When transpor ng or temporarily storing the ba ery, the temperature range should be between 40 to 100F.
Do not store the ba ery or boat in a hot car or in direct sunlight whenever possible or the ba ery could be
damaged or even catch fi re.
• LiPo cells should not be discharged to below 3.0V each. In the case of this 1-cell, 3.7V ba ery you should not
allow the voltage to fall below 3.0V during opera on.
• Do not over-discharge the LiPo ba ery, which could result in reduced power, lower run mes or complete failure
of the ba ery.
NOTE : Your aircra features a “so ” LVC (Low Voltage Cutoff ) that smoothly reduces power (regardless of your
thro le posi on) to let you know the ba ery is near the minimum voltage to avoid damage to your ba ery.