background image

1.1 The bike carrier had been designed and manufactured to attach securely to a

      variety of vehicles with cross bars on the roof. The attachment of this bike carrier to a      

      vehicle is beyond the control of the manufacture. The users must therefore ensure that the   

      bike carrier is stuitable for use with their particular vehicles/rails and that bikes are securely 

      and safely attached to the bike carrier.

1.2 During the jourmey, please check the attachment of bike carrier to cross bars constantly 

      and cautiously.Retighten the knobs if necessary. Make sure all the parts are in good 

      condition. Contact authorized dealer if any part needs attention.

1.3 Always obey the national law about the bike carrier.

1.4 The maximum load for this biks carrier is 15 kgs(35 lbs). Do not over load! Also maintain 

       the minimum distance between two cross bars at 40cm (15 in).

1.5 Reduce the speed on rough road.

1.6 This bike carrier is designed for temporary use only, remove when not in use or druing the 

       bad weather.

1.7 Failure to obey the guideline in the instruction will void the warranty.

CAUTION

ITEM:BC-219

  

 NAME:Roof mounted bike carrier

Содержание BC-219

Страница 1: ...nobs and three anti skid plates At front side make sure front roof bar is between four screws underneath front housing According to distance of rear cross bar move the two screws accordingly so that rear roof bar is within the two screws Caution it is required to have the minimum distance between two roof bar at 40 cm 15 75 inch which gives bike carrier the best support Wheel tray 1 Front housing ...

Страница 2: ...rrect installation of front part of bike carrier on front roof bar Double check all knobs and if any knob is loosened re tighten it This diagram illustrated correct installation of bike carrier on roof bars Before mounting bicycle loosen the knob located inside the tire holder by turning anti clockwise Now the tire holder moves freely Remove the front tire from the bicycle mount the fork mount ont...

Страница 3: ... 15 and 16 if it is not secured Turn the knob of wheel holder in a clockwise way until the knob is tightened Secure one end of the rubber strap with one side of wheel holder After bikes are mounted secure the other end of the rubber strap with the other side of wheel holder The diagram illustrates the final installation of bike carrier and bicycle ...

Страница 4: ...ke carrier to cross bars constantly and cautiously Retighten the knobs if necessary Make sure all the parts are in good condition Contact authorized dealer if any part needs attention 1 3 Always obey the national law about the bike carrier 1 4 The maximum load for this biks carrier is 15 kgs 35 lbs Do not over load Also maintain the minimum distance between two cross bars at 40cm 15 in 1 5 Reduce ...

Отзывы: