PROGRAMMING & CALIBRATION
3-7
3.3. Change Alarm Limits
Alarm limits can be changed using the keystrokes in Table 5.
The average type can be set to either “Running Average” or
“Time Weight Average” (TWA) under the “Change Averaging
Method?” sub-menu of the “Change Monitor Setup?” menu
3.4. Change
Datalog
Datalog parameters can be modified using the keystrokes in
Table 5. Additional datalog options can be programmed using
a PC and downloaded to the monitor (see ProRAE Suite
Manual for details). Datalog options include:
1. “Clear All Data?” clears all the stored data.
2. “Change Datalog Period?” the interval between stored
measurements can be set from 1 to 3,600 seconds.
3. “Select Data Type?” A choice of peak or average reading in
the datalog period will be stored.
4. “Enable / Disable Datalog?” activates or suspends the
datalog function, as indicated by an asterisk (*) next to an
enabled sensor’s name.
5. “Select memory full type?” allows a choice of “wrap
around,” overwriting the oldest data, or “Stop” storing data
when memory is full.
3.5. Change Monitor Setup
1.
Site ID
– An 8 digit alphanumeric location identifier to be
included on datalog reports.
2.
User ID
– An 8 digit alphanumeric user identifier to be
included on datalog reports.
3.
Alarm Mode
– Determines whether the alarm will latch or
automatically reset after an alarm situation occurs.
4.
User Mode
– Basic or Advanced Mode controls access to
programming menus, information and security levels.
