Radyne ComStream SFC6400A, Инструкция по установке и эксплуатации

Страница: 51 / 156

User Interfaces SFC6400A/SFC1450A Synthesized Frequency Upconverter
4-28 TM106 – Rev. 1.1
The following response error codes are specific to the SFC Upconverters:
SFC6400A/SFC1450A Response Error Code Descriptions OPCODE
Remote Control Error 200h
Remote Time Error 201h
Remote Date Error 202h
Remote Frequency Error 203h
Remote Gain Error 204h
Remote Channel Error 205h
Remote Carrier Control Error 206h
Remote Input Attenuation Error 207h
Remote Converter Configuration Error 208h
Remote Backup Mode Error 209h
Remote Force Manual Backup Error 20Ah
Remote Learn Configuration Error 20Bh
Remote Backup Test Error 20Ch
Remote Compensation Control Error 20Dh
Remote Compensation Error 20Eh
Remote Priority Error 20Fh
4.4.2.5 Collision Avoidance
When properly implemented, the physical and logical devices and ID addressing scheme of the
COMMSPEC normally precludes message packet contention on the control bus. The importance
of designating unique IDs for each device during station configuration cannot be overemphasized.
One pitfall, which is often overlooked, concerns multi-drop override IDs. All too often, multiple
devices of the same type are assigned in a direct-linked "single-thread" configuration accessible to
the M&C computer directly. For example, if two
Converters with different addresses DESTINATION
IDs are linked to the same control bus at the same hierarchical level, both will attempt to respond to
the M&C computer when the computer generates a multi-drop override ID of 1. If their actual setup
parameters, status, or internal timing differs, they will both attempt to respond to the override
simultaneously with different information, or asynchronously in their respective message packets
and response packets, causing a collision on the serial control bus.
To preclude control bus data contention, different IDs must always be assigned to the equipment. If
two or more devices are configured for direct-linked operation, then the M&C computer and all other
devices configured in the same manner must be programmed to inhibit broadcast of the
corresponding multi-drop override ID.
The multi-drop override ID is always accepted by devices of the same type on a common control
bus, independent of the actual DESTINATION ID. These override IDs with the exception of
“BROADCAST” are responded to by all directly linked devices of the same type causing contention
on the bus. The “BROADCAST” ID, on the other hand, is accepted by all equipment but none of
them returns a response packet to the remote M&C.