Radwin Transportation FiberinMotion, Руководство по развертыванию

Страница: 44 / 122

FinM Deployment Guide Release 4.5.10 2 ‐ 31
Waterproofing Site Installation
2. Attach the LPU to the wall using wood or masonry screws (not included), via the
holes as shown in Figure 2 ‐ 61 .
3. Connect the left screw (where the grounding lug was located) to a ground source.
4. Remove the cable glands.
5. Thread the CAT ‐ 5e/6 cables through the cable glands, and connect the cables to the
LPU as shown in Figure 2 ‐ 58 .
6. Tighten the cable glands around the CAT ‐ 5e/6 cables as shown in Figure 2 ‐ 59 .
7. Route one CAT ‐ 5e up to the radio (via the upper LPU), and the other to the IDU or
PoE.
8. RADWIN recommends that you add extra waterproofing to the connections
(see see Waterproofing on page 2 ‐ 31 ).
Figure 2 ‐ 61: Installing an LPU on a wall
2.2.9 Waterproofing
Protect all connections between any outdoor devices and cables from rain, dust, moisture
and salt according to the procedure below:
1. Use a high quality sealing material such as Scotch 23 Tape ¾” wide, to ensure IP ‐ 67
compliant protection against water and dust.
2. Cut two pieces each 25 cm long, of Scotch 23 splicing tape. Remove the plastic
cover to expose the tacky side of the sealing tape as shown in Figure 2 ‐ 62 .