5.2.11. Repeat the process by tightening the screws on the left side of the device.
5.2.12. A total of 8 screws should be used: two on top, three on the right side and three on the left
side.
5.3
Safety
5.3.1. Lightly shake the device to verify no foreign object has been left inside (e.g. strips leftovers,
screws etc.).
If a suspicious noise is heard, locate and remove the object.
5.4
Verification & Completion
5.4.1. Verify that the power cable is connected and reboot the device.
5.4.2. Verify that the log file presents the indication that a compression card is installed.
5.4.3. Reboot the device 5 consecutive times.
5.4.4. After each reboot verify that the device is operating correctly.
5.4.5. If device is operating without failure after all reboots, turn off the device.
The device is now ready for normal operation.
Содержание ODS-3XL
