Radware DefensePro VA, Руководство по установке и обслуживанию

Страница: 76 / 83

DefensePro VA Installation and Maintenance Guide
Configuring DefensePro VA in PCI Passthrough Mode
76
Document ID: RDWR-DPVA_IG2005
Validating the PCI Slot Addresses
After the NICs are in their slots, determine the PCI addresses of the ports.
The main action in configuring DefensePro VA in passthrough mode is identifying the PCI port
addresses of the physical Ethernet ports.
The following procedure is applicable for DefensePro VA running on KVM hypervisor.
A similar procedure is required for DefensePro VA running on VMware.
To configure DefensePro VA in passthrough mode for KVM
1. Run the following Linux command:
lspci -vv>PCImapping.txt
This command creates a file, PCImapping.txt , which includes the PCI mapping of the host (see
the example in Figure 20 - PCImapping.txt Example, page 77 ).
2. In the PCImapping.txt file, search for the string "Physical Slot: 5" (for example, if the NIC was
inserted into slot number 5).
In
Figure 20 - PCImapping.txt Example, page 77 , the string "Physical Slot: 5" is shown marked
(1).
3. Above the string "Physical Slot: 5", at the beginning of the section, find the string "Ethernet
Controller" (marked (2) in the example).
4. The numbers at the beginning of the row ("84:00.0" in the example) are the PCI address of the
first port on that slot.
5. Write down the PCI address. You will need it for the installation wizard.
6. Perform
step 2 through step 5 to repeat this search for the PCI addresses of all the ports on the
slot.
7. Perform step 2 through step 5 to repeat this search for all the NIC slots on your server.