Chapter 2 | Installation Workflow for Scopia
XT Series
About this task
To safely set up and perform the required initial settings to start using the Scopia XT Series, follow the recommended
workflow described below.
Procedure
1. Decide how to incorporate the XT Series into your deployment, as described in
the Scopia XT Series Deployment
For example, decide whether to enable license options such as a built-in MCU, where to deploy the XT
Series, and the ports to open.
2. Read through and familiarize yourself with the safety information (see
Complying with Safety Regulations
on page 32).
3. Inspect the XT Series to verify that no shipping damage occurred, as described in
on page 32.
4. Decide where to place your XT Series, depending on the room setup (see
5. To quickly connect your XT Series, refer to the
Quick Setup Guide for Scopia XT Series
. For more
detailed information on connecting the XT Series, see
Setting up the Scopia XT Series
on page 35,
which includes:
• Mounting the XT Series
• Connecting the XT Series to the network
• Connecting a computer
• Connecting the audio equipment, such as the Microphone Pod
• Connecting the video equipment, such as the camera
• Placing batteries in the XT Remote Control Unit
6. Read through and familiarize yourself with how to control the XT Series and access both the endpoint and
web interface, as described in
on page 61.
7. Register your license to activate the XT Series, as described in
Registering and Enabling your Scopia XT
on page 75.
If you do not yet have your license key, you can set up the system in demo mode for a period of 24 hours.
After this time, you must enable your license key to use the system.
8. Perform the basic required configuration necessary to use the XT Series, such as the network and
gatekeeper settings, as described in
Performing Basic Configuration
Installation Guide for Scopia XT5000 Series Version 3.2
Installation Workflow for Scopia XT Series | 17
