RADVision SCOPIA Elite 5200, Руководство по обслуживанию

Страница: 13 / 17

Performing Hardware Maintenance | 10 RADVISION | Maintenance Guide for SCOPIA Elite 5200 Series MCU Version 7.7
P/N 61546-00011
•
An antistatic wrist strap
•
A PSU. To order, contact your local RADVISION representative using the reference listed in
this table.
Table 1-5 Replacement power supply for SCOPIA Elite 5200 Series MCU
Procedure
Step 1
Verify that the redundant PSU switch is turned off.
Step 2
If you perform this procedure for the first time, turn off the MCU.
Step 3
Remove the PSU cover (see Figure 1-7 on page 10 ):
a. Insert the slot head screwdriver into the opening on the left side of the PSU cover and gently
push sideways.
Figure 1-7 Removing the PSU cover
b. Insert the slot head screwdriver into the opening on the right side of the PSU cover and gently
push sideways.
c. Repeat steps a and b in turn until the PSU cover is released from its clips.
Step 4
Locate the cover of the PSU compartment which covers the PSU empty slot (see Figure 1-8 on
page 11 ).
Note:
Set the cover of the PSU compartment aside for use as a spare part.
Name Part number
SCOPIA Elite 5200 Series MCU AC Power Supply 55546-00613