Setting up the SCOPIA Elite 5200 Series MCU | 11
RADVISION | Installation Guide for SCOPIA Elite 5200 Series MCU Version 7.5
Adjusting the Bracket Length
You must adjust the length of each bracket to correspond with the depth of your rack. Each
bracket has two pieces that slide one inside the other, with three elliptic hole settings for
adjusting the length, as shown in
.
Figure 3-4
Adjusting Bracket Length - Open View
To adjust the bracket length to correspond with the rack’s depth, from the mounting kit, you
need:
•
Both left and right brackets
•
The Allen wrench
Procedure
Step 1
Use the provided Allen wrench to release the bracket’s Allen screw.
Step 2
For each bracket, slide the two bracket parts until the round hole meets the elliptic hole
corresponding to the depth of the rack.
Step 3
Insert the Allen screw where both holes meet.
