9
To reduce the influence of vibration and noise, limit working hours and wear personal
protective equipment. Observe the following points to minimize vibration and noise
exposure:
1. Use the tool only in accordance with its design and instructions.
2. Ensure that the product is in good condition and well maintained
3. Use the correct accessories and ensure that they are in good condition.
4. Hold the tool firmly but not tightly by the handles provided.
5. Maintain the product according to these instructions and keep it lubricated.
BATTERY & CHARGER SAFETY
VIBRATION AND NOISE REDUCTION
WARNING: Only use the diagnostic charger supplied with this kit to charge
the 20V Li-ion battery. Charging any other batteries may damage the charger
and possibly cause serious injury.
1. FOR BATTERY PACK
a) Before using the battery pack, read all instructions and cautionary markings on
battery and product using battery pack.
b) If operating time has become excessively shorter, stop operating immediately to
avoid the risk of overheating and possible burns.
c) Do not short the battery pack:
1) Do not touch the terminals with any conductive material.
2) Avoid storing battery pack in a humid environment.
3) Do not expose the battery pack to water or rain. A short circuit of the battery can
cause a large current flow, overheating, possible burns and even a breakdown.
d) Do not store the tool and battery pack in locations where the temperature may
exceed 105° F (40.5° C).
e) Do not incinerate the battery pack even if it is severely damaged or is completely
worn out. The battery pack can explode in a fire.
f) Be careful not to drop or strike the battery.
g) Do not use a damaged battery.
2.FOR CHARGER
a) Before charging, study the instruction manual carefully.
b) Before charging the battery, connect the power cord into the power supply first and
then connect the battery pack with the charger.
Once the battery is fully charged, disconnect the power supply after removing the
battery pack from the charger.
c) This device is for indoor use only. Do not expose the charger to rain, snow, or other
extreme climate conditions. Do not use power tools in damp or wet locations.
d) Correct use: chargers are to be used exclusively for charging 20V Radley Recharge-
able Battery Packs. Any other application may result in risk of fire, electric shock, or
electrocution. The user bears sole responsibility for any damage caused by inappropri-
ate use.
e) The charger is specifically designed to charge 20V Max Radley Battery Packs. Do not
attempt to charge any other battery with this charger.
f) To reduce risk of damage to electric plug and cord, pull by plug rather than cord
when disconnecting charger.
g) Make sure cord is appropriately located so that it will not be stepped on, tripped
over, or otherwise subject to damage or stress.
