5125-018
16
CHECKING THE BATTERY CHARGE STATUS
CHARGING THE BATTERY PACK
Press and hold the battery status button located on the end of the battery
One or more of the three LED lights in the LED window will come ON to
indicate the amount of charge that is remaining in the battery as follows:
1.
2.
Place the battery charger in a dry location near a 110-120V 60 Hz
electrical outlet (Fig. 7).
Plug the battery charger into the outlet and make sure the green LED
indicator light comes ON. If it does not, refer to the chart (Fig. 8) to identify
the problem.
Turn the battery pack upside down and slide it onto the charger .
1.
2.
3.
The level of charge remaining in the battery can be checked by using the battery
LED power indicator that is contained on the end of the battery.
NOTE:
The battery charge remaining may be checked while the battery is
installed in the tool with the ON/OFF switch turned OFF. It may also be checked
while the battery is removed from the tool. DO NOT check the battery charge
remaining while the battery is in the charger.
NOTE:
Make sure the grooves in
the sides of the battery slide over
the matching tabs on the charger
until the battery latch “clicks” into
place.
WARNING:
Charge in a safe location away from moisture and heat
sources!
You will get a false reading and you may also damage the battery status system.
FIG.6
3. Release the battery status button to turn the LED’s OFF.
1 light
(Red light ON)
2 lights
(Red and Orange
light ON)
3 lights
(Red/Orange/Green
ON)
-Fully charged
1
/
3
or less
1
/
3
-
2
/
3
2
/
3
Fig. 7
