RADLEY 5073-356, Руководство пользователя

Страница: 19 / 26

18
5073-356
Remove the discharged battery pack (1) from the tool by pressing the battery
release button (2) on the rear of the battery downward (Fig. 3) and pulling the
battery pack out of the tool handle (3) (Fig. 4).
Insert the fully charged battery pack into the matching slots in the rear of the
tool handle where the discharged battery pack has been removed.
NOTE:
The battery release button will “click” into place when the battery pack
is fully installed.
INSTALLING THE BATTERY PACK IN THE BLOWER
1.
2.
Insert the small end of the rear nozzle section (1) into the large end of the front
nozzle section (2) (Fig. 5).
Push the two nozzle sections until the nozzle release button (3) “clicks” into
place to lock the nozzle sections together.
ASSEMBLE & INSTALL NOZZLE
ON/OFF SWITCH
Assemble rear and front nozzle sections as follows:
1.
2.
Slide the large end of the rear nozzle section (4) over the blower intake (5) (Fig. 6).
Push the rear nozzle section firmly onto the blower intake until the nozzle
release button (6) “clicks” into place locking the nozzle assembly onto the
blower intake.
Install the nozzle assembly to the blower as follows:
To turn the blower ON, slide the ON/OFF switch (1) forward (Fig. 7). To turn the
blower OFF, slide the ON/OFF switch toward the rear of the tool.
3.
4.
WARNING: Do not immerse battery pack in water. Sudden cooling could cause
a hot battery to explode or leak.
Fig. 3 Fig. 4 Fig. 5
Fig. 6 Fig. 7
1