RADLEY 1262-300, Руководство пользователя, Страница: 16 / 20

15
1 /
4
Sheet Sander - Owner's Manual
MAINTENANCE
GENERAL
WARNING: When servicing, use only
identical replacement parts. Use of any
other replacement parts may create a
hazard or cause product damage.
DO NOT use solvents when cleaning
plastic parts. Most plastics are susceptible
to damage from various types of
commercial solvents and may be damaged
by their use. Use a clean cloth to remove
dirt, dust, oil, grease etc
WARNING: Do not at any time allow
brake fluids, gasoline, petroleum-based
products, penetrating oils, etc. to come in
contact with plastic parts. They contain
chemicals that can damage, weaken or
destroy plastic.
DO NOT abuse power tools. Abusive
practices can damage the tool as well as the
workpiece.
WARNING: DO NOT attempt to
modify tools or create accessories not
recommended. Any such alteration or
modification is misuse and could result in
a hazardous condition leading to possible
serious injury. It will also void the warranty.
It has been found that electric tools are
subjected to accelerated wear and possible
premature failure when they are used on
fiberglass boats and automotive parts,
wallboard, spackling compounds or plaster.
The chips and grindings from these materials
are highly abrasive to electric tool parts
such as bearings, brushes, commutators,
etc. Consequently, it is not recommended
that this tool be used for extended work on
any fiberglass material, wallboard, spackling
compounds or plaster. During any use on
these materials it is extremely important that
the tool is cleaned frequently by blowing the
dust out of the tool with an air jet.
WARNING: Always wear safety goggles or
safety glasses with side shields during all
sanding operations. It is critical that you also
wear safety goggles or safety glasses with
side shields and a dust mask while blowing
dust out of the sander with an air jet. Failure
to take these safety precautions could result
in permanent eye or lung damage.
LUBRICATION
All of the bearings in this sander are
lubricated with a sufficient amount of high
grade lubricant for the life of the unit under
normal conditions. Therefore, no further
lubrication is required.