RADLEY 1262-300, Руководство пользователя

Страница: 12 / 20

11
INSTALLING SANDPAPER – cont’d
1. Place the hole punch (1)
2. Wrap the sandpaper sheet (3) over the backing pad (2) and insert it into the
open rear sandpaper clamp (5) (Fig. 5).
NOTE: Make sure the sandpaper is pulled tight over the backing pad for proper
sanding operation.
3. Wrap the sandpaper sheet (3) over the backing pad (2) and insert it into the open
rear sandpaper clamp (5) (Fig. 5).
4. Lift the sandpaper clamp lever up and inward to lock the sandpaper into the clam
NOTE: Make sure the sandpaper is pulled tight over the backing pad for proper
sanding operation.
PUNCHING HOLES IN SANDPAPER
The sandpaper must have 8 holes punched in it to allow the sanding dust to escape
from the working surface. The pattern of these holes must match the hole pattern on the
sanding pad. If the sandpaper you are using does not have the holes punched, use the
hole punch supplied with the tool to pierce the sandpaper in the correct locations.
2. Align the corner of the sanding pad (2) with the corner of the hole punch (3).
This will ensure the holes are punched in the correct location.
3. When the sanding pad is correctly aligned on the hole punch, press the sanding
NOTE: The sharp pegs (4) in the hole punch will pierce the sandpaper in the
correct location.
SANDPAPER SELECTION
Selecting the correct grit and type of sandpaper is extremely important in achieving
abrasives are best for power sanding.
Natural abrasives such as flint and garnet
are too soft for economical use in power sanding
.
until the surface is uniform. Medium grit may then be used to remove scratches left by
Always continue sanding with each grit until the surface is uniform.
Fig. 6 Fig. 5 Fig. 4