FP104780-SP1_revD.docx
Page
3
of
5
1) In addition to the items listed in Pole Mount Installation Guide
AP103230-1, you will receive a “diamond” mount adapter plate
attached to a flat adapter plate with your SP1 series antenna.
These plates are shipped in the same box as the antenna, and
packed with the pole mount. You will need a #2 Phillips screw
driver to install the plates.
2) Prior to attaching the mount assembly to the
pole, install mount adapter plates on antenna
as shown. Tighten securely.
3) Proceed with installation and adjustment per
Pole Mount Installation Guide FP103230-1
Mounting Options
To Install for Left Side Pole Mount –
1. Place Antenna on Flat Surface
2. Remove (4) 10-32 screws that attach Antenna Mount to the Flange
3. Carefully rotate Antenna 180 degrees
4. Re-attach Antenna Mount to Flange
5. Drain Hole (Bottom) should be facing the ground (applicable if radome is installed)
To Change Polarization –
1. Remove (4) 8-32 screws that attach the Feed to the Reflector
2. Carefully rotate the Feed 90 degrees
3. Re-install hardware and tighten.
Note:
For Dual Band Antennas, the Feed is factory installed for 2.44GHz Vertical & 5.8GHz Horizontal.
For Single Band Antennas, the Feed is factory installed Vertical Polarization.
“Diamond” Mount
adapter plate attached to
flat adapter plate
Flat Adapter plate: Attach using
(2) 1/4-20 screws, lock washers
and flat washers provided with
antenna. Use holes nearest
edge of plate as shown.
Tighten securely.
Ensure slot
faces away
from antenna.
Содержание SP1 Series
Страница 5: ... FP104780 SP1_revD docx Page 5 of 5 ...
