D7212 Operation & Installation Manual
Page 17
© 1993-1996 Radionics
74-06913-000-B 2/96
Make the Telephone Connections
See
Telephone Connections. If you are connecting the D7212 to a ground start phone
system, you need to install D136 relay, see
Install Modules and Relays on the previous
page.
Connect the On-Board Points and Command Centers
Connect the on-board point and command center wiring to the D7212. See the
On-Board
Points and Arming Devices sections for instructions.
Power Up
Reconnect the battery and then plug in the transformer. Remember the buzzer sounds for
10 seconds when you first power up the panel.
Leave the reset pin locked down for now.
Yellow Charging Status LED doesn’t go out: If the yellow charging status LED doesn’t
go out within 5 minutes of powering up the panel, the battery may be deeply discharged, or
you may have connected too many powered devices to the panel. Combined continuous
current draw for terminals 3, 8, and 32, and the Accessory Connector (J2) cannot exceed
1.4A. See the
Power Outputs section for help.
Programming the Panel
If you haven’t created a program for the panel, review the
D7212 Program Entry Guide (74-
06915-000). Check to be certain you have all the required accessory modules installed for
the features you want to use.
Use the D5200 Programmer or the RAM II remote programmer to load your custom
program into the panel.
Move the reset pin to the normal position. See Figure 3. The panel transmits reboot and
battery reports to the receiver.
Install the Point Chart Label
Point chart label required for fire systems with verification points: You must install the
point chart label for fire or combined fire/burglary systems using verification points.
Use the program record sheet to gather the information you need to fill out the point chart.
Install the label on the enclosure door as shown in figure 2. To avoid smearing your entries
on the chart, use the label's peel off backing to press the label in place.
