D279A User Guide
46457D
Page 2
© 2001 Radionics
D279A
User Guide
ARMED
- The red ARMED indicator is lit when the area is armed
and not lit when the area is not armed. During exit delay (after
the passcode is entered) the ARMED indicator blinks.
The
indicator will not blink with alarm memory.
Note:
Both the
DELAYED
and
INSTANT
indicators must be lit before
arming.
The Digital Keypad
The Zone Control has a digital keypad used to enter your
passcode into the security system. It is your passcode which
arms and disarms the delayed and instant areas.
When entering your passcode, if the Zone Control emits a short
warning tone each time you touch a key, check the DELAYED
and INSTANT indicators. Both LEDs should be lit. If either LED
is NOT lit, check doors, windows, and motion detector vicinities
in the protected area.
Arming
1) Ensure that the area is secure.
The green DELAYED and INSTANT lights must be on.
2) Arm the area by entering your passcode.
The red ARMED indicator light flashes on and off to indicated
exit delay time (approximately 60 seconds). When the
ARMED indicator lights steadily, the delay and instant areas
are armed.
Disarming
Disarm the area by entering your passcode.
When the area is armed, you must enter the premises through
a designated entry door to prevent an instant alarm condition.
Opening the delay door starts a 30-second delay during which
the Zone Control sounds a warning to remind you to disarm the
system. To disarm the system, enter your personal passcode
before the entry time expires. If you enter through a wrong door,
or fail to disarm the system before the entry delay expires, you
will generate an alarm.
Note:
If both the DELAYED and INSTANT loops are faulted at the end
of the exit delay, an entry delay will be initiated (not an instant
alarm).
