Radionics D2112, Руководство пользователя

Страница: 10 / 35

9
How Your System Reports Alarms
Your security system may be programmed to automatically
disconnect your telephones when sending reports to your security
company. Once the report is completed, your security system
returns the telephones to normal operation (check with your
security company).
Your system makes repeated attempts to send reports to your
security company. In the event your system fails to report, the
keypad will signal a system trouble. Follow the Checking System
Troubles procedure.
Note: If your telephone service is interrupted, your security
system cannot send reports to your security company unless it has
an alternate means of transmitting them.
Silencing Alarms
When there is an alarm, the alarm tone sounds and the point or
points in alarm light up. If you enter your passcode before the
system dials your alarm company, the alarm is canceled.
1. When an alarm occurs, the OK light and point lights (1 to 8)
flash. For example if point 4 produces the alarm event, then point
4 flashes:
2. Enter your passcode to silence the alarm. If you enter your
passcode before the system dials your alarm company, the alarm is
canceled and the OK light stops flashing. If the OK light contin-
ues to flash, an alarm report was sent to your alarm company.
3. Use Viewing Alarm Memory to review the points that caused
the alarm. Use Resetting The System to reset the OK light and clear
alarm memory.