Item No. 511428 - Adjustable Holder for Small to
Medium Cases.
Compatible with:
Apple iPhone 5 / 5s / 5c
Device thickness (6 mm) to (10 mm)
Width adjustment (62 mm) to (77mm)
For iPhone 5 with Small to Medium Cases
WARNING:
Please hold the vehicle mount and holder over the place where the mount attaches to the dash before installing them
to insure you like the location of the solution. Once installed and screwed together the products are non-refundable.
Important:
Self-installation instructions and advice are provided for your
convenience. It is your responsibility to determine if you have the
knowledge, skills, and physical ability required to properly perform an
installation. ProClip USA, Inc. shall have no liability for damage or
injury resulting from the installation or use of any ProClip or third
party products. It is your responsibility to ensure that all products are
installed in adherence with local laws and regulations and in such a
manner as to allow a vehicle to be operated safely and without
distraction. ProClip USA, Inc. product warranties do not cover the
installation, removal or reinstallation of any product.
Attention:
Carefully read all instructions and review the images before installing this product.
To view an installation video, visit this link: https://www.youtube.com/watch?v=VpZSriVO0zw&feature=youtu.be
1. To fit the holder to your device: Loosen the left and right screws in the holder
to release the sides. Then slide the holder sides apart to widen the holder.
Place the device in the holder and press the sides together so the device is
held in place. Next, carefully remove the device without changing the position
of the holder sides.Tighten the left and right screws in the holder to lock the
sides into the correct position, suitable for your device.
3. Place the Tilt Swivel base plate over the matching holes in your mounting
bracket (demo ProClip mount shown in picture) Attach the base plate by using
the applicable screws. (Enclosed self-tapping screws if the mount has small
holes or the machine screws with nuts if the mount is made of metal and has
large holes. Place the Holder onto the Tilt Swivel base plate and reattach it with
the center screw. The center screw also controls the pivot, tighter for a firm
hold and loose for more (easier) movement/angling of the Holder.
2. To install the holder onto a mount: Unscrew ONLY the one screw in the center of
the Holder. (See photo) This will remove the Device Holder portion from the Tilt Swivel
base plate.
4. Slide the device down into the Holder. To remove the device from the Holder, slide
it up and out. Rotate the holder in a landscape position if needed.
