Firmware V1.1.4 Upgrade Instructions
1. Fix the problem that the function cannot normally be triggered by the button
when the PS button is changed to the DT button in the Double ratio setting
menu.
2. Fix the problem that the positions of the Spur and the 2nd gear ratio are
interchanged in the Gear ratio chart menu.
3. Fix the problem that the gyro function cannot typically work if the protocol
selection selects the FHSS V2.
4. If the protocol selection selects the FHSS V2, it defaults to the gyro function
controlled by the CH8 and does not need to be set in the Channel setting menu.
Firmware V1.1.3 Upgrade Instructions
Add the receiver communication protocol selection prompt in the "Receiver
setting" menu.
The V1.0 version of R8FG only supports the FHSS V1 protocol and does not
support the FHSS V2 protocol.
The V2.0 version and the V1.0 that product after February 6th, 2023 of R8FG
support FHSS V1 and V2 protocols.
The PWM output resolution of the FHSS V1 protocol is 2048 levels, while the
PWM output resolution of the FHSS V2 protocol is 4096 levels, and the FHSS V2
protocol can obtain a more precise operation.
The version number of the receiver can be checked on the R8FG sticker.
Firmware V1.1.2 Upgrade Instructions
1. Repair the model does not report errors when it fails to select but opens the
Model_1 automatically.
2. Fix the problem that the parameters will fail to save when selecting a new
model if the RC8X has been powered off abnormally.
3. Model sorting is sorted according to the model creation time.
4. When creating a new model, automatically enter the rename interface to
avoid stuttering when the number of models is created too much.
5. Fix the problem that the model data being deleted when using special
characters to rename the model.
6. In the “Battery” menu, add no operation alarm prompt function and no
operation automatic power-off function.
7. Repair the model renamed only in English to display problems
8. In the case of non -compulsory shutdown, the device shutdown will prompt
“Please power off the receiver first to avoid accidents! Do you want a forced
shutdown?”.
9. In the “Trim/Dial select” menu, add the trimers back to the center
automatically function.
