RadioLink Electronic Ltd
13
Aux Servo EPA
Aux Servo EPA
CH5:0%~120%(left/ right)
CH6:0%~120%(left/ right)
Initial value: 100%
Initial value: 100%
End point adjustment
(1) Long press "Exit" and "Enter" button simultaneously for one second
to enter the function menu of RC6GS V3. Press "Inc(+)" button at the
bottom of the screen to move the cursor to "3. EPA", and then press "
Enter” button to enter the function setting interface.
(2) Switch setting: Set a switch or button to switch in different end points.
A. You can set SWA, SWB, SWC, SWD, or the lock modes of these
four switch buttons LK-A, LK-B, LK-C, LK-D.
B. "NULL" means no switch assigned. After setting the end point parameter of the corresponding channel,
the transmitter will always execute the set end point by default.
C. UP (up)/DOWN (down)/CNT (central): It indicates the position of the selected switch. Push/Press the
switch to different positions to set different end points.
D. Setting method: Press "Dec(-)" or "Inc(+)" button at the bottom of the screen to move the cursor to
"NULL" next to the switch, then press "Enter" button, the corresponding setting starts to flash, then press
"Dec(-)" or "Inc(+)" button to select the switch or button to be set, and press "Enter" button to confirm the
option after the selection. The switch setting stops flashing and the switch setting is complete.
(3) Set the end point of each channel: press “Dec(-)” or “Inc(+)” button to move the cursor to the rate next to
the channel, and then press the “Enter” button, the corresponding value starts to flash , and then press
“Dec(-)” or “Inc(+)” button to adjust the rate value. After setting, press "Enter" key, the rate value stops flashing,
and the channel rate value is set.
(4) Press "Exit" to return to the home page.
2.5 Steering Exponential "STEXP"
This function is used to change the sensitivity of the steering
servo around the neutral and both ends position. It has no effect
on the maximum servo travel.
Adjust the sensitivity of direction wheel both in neutral position and ends.
Setup Item
RATE: Steering EXP rate
Adjustment range
-100%~0%~+100%
Initial value: 0%
0%~-100%: Sensitivity around neutral position is low, getting higher when approaching ends.
0%: Sensitivity around the neutral and ends position is equal
0%~+100%: Sensitivity around neutral position is high, getting lower when approaching ends
Steering operation curve adjustment
(1) Access the function menu (By pressing “Exit” and “Enter ”buttons simultaneously and holding them down
for one second ), press “Inc(+)” button three times to chose EAP function.
(2) Press “Enter” button to get into STEXP function interface, press “Enter”key and the initial value of the rate
